COTTO Dhobi White Drop-In Basin - 620 x 480 x 255mm

Step 1. - Mark The Area Of The Sink

- Carefully place the Dhobi sink upside down on the kitchen/laundry counter.

- Draw a line around the dhobi sink making sure the dhobi sink edge is parallel to the counter edge.

Step 2. - Place Cutting Template

- Place the paper template provided with the basin on top of the counter and secure it with masking tape or office glue.

- Align this template with the line you had drawn earlier in Step 1.

- Cut out the template along the dotted line using a scissor or box cutter as shown on the template. It is important to mark the hole for the tap on the counter if you will be using a pillar tap.

Click below to download a soft copy of the desired paper template for your basin.

Step 3. - Cut Hole For The Dhobi Sink

- Using the electric jigsaw, cut the hole along the straight cut lines on the template.

- Once the hole is cut and the sink fits you can remove the paper template.

- Before you install the dhobi sink please make sure you have drilled the hole on your counter for a pillar sink mixer. If your sink mixer is a wall type then you do not need to drill this hole.

Tip : Install the waste/drain into the dhobi sink before dropping it into the cut hole. This will be easier to do now. Make sure you apply silicon around the waste for a water tight seal.

Step 4. – Lower The Dhobi Sink In Place.

- Apply a bead of silicone around the edge of the hole and the edge of the dhobi sink from the inside.

- Drop the dhobi sink in place and apply even pressure on all sides.

- Make sure there are no gaps in between the counter and dhobi sink.

- Remove and wipe out any excess silicone that sips out.

- Now you can connect your bottle trap to the dhobi sink waste.

- You can than connect the bottle trap to the sewage drain.

Step 5. – Installation Complete.

- Your dhobi sink installation is now complete.

- Wait 24 hours for everything to dry and then open the water to check for any leaks.